Table of Contents
Advertisement
5 Update your player
Your player is controlled by an internal program called the firmware. Newer versions of the
firmware may have been released after you have purchased your player.
A software program called Philips Device Manager checks for firmware updates that are
available on the Internet.
Install Philips Device Manager from your player or download the latest version from
www.philips.com/support.
5. Manually verify software status
Attention This procedure will erase the content of the player.
1
Copy the content of the player to the computer as a back-up.
2
Disconnect the player from the computer.
Turn off your player.
3
4
Ensure the computer is connected to the Internet.
5
Click Start > Programs > Philips Digital Audio Player > GoGear Spark > Philips
GoGear Spark Device Manager to launch the Philips Device Manager.
6
On the player, hold the
>
The Device Manager enters recovery mode.
7
Click OK to continue.
8
When the display indicates that the process is finished, disconnect the player from the
computer.
The display shows Updating firmware.
>
9
Wait until the update process is completed on the player.
>
The player restarts and is ready for use again.
10
Reconnect the player to the computer.
11
Transfer the back-up content to the player.
24
OPTIONS
button while you connect the player to the computer.
Advertisement
Table of Contents
