HP OfficeConnect 1850 6XGT 2XGT/SFP Series Quick Setup Manual And Safety/Regulatory Information page 5

8–port switch:
Table or desktop mounting: Attach the four self-adhesive pads (included in the accessory
kit) to the bottom corners of the switch and place the switch on a secure horizontal surface.
Wall or Under-Table Mounting: To mount the 1850-24G, 1850-24G-POE+, 1850-48G, and
1850-48G-POE+ switches, Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws. Attach the switch to the wall or
wood surface with two 5/8-inch number 12 wood screws (not included).
To mount the 1850-8XG switch, mark the position for the mounting screws. The hole-to-hole
distance is 3.54 inch (90mm). Use a #1 Phillips (cross-head) screwdriver and two of the
included 20-mm M4 tap screws. Set the screw heads approximately 2mm away from the
mounting surface to allow the switch to slide onto the screws. Wall anchors are included in
the accessory kit for use with plastered brick or concrete walls.
For under-table mounting, a third 20-mm M4 tap screw can be placed against one side of
the switch to secure it in place.
IMPORTANT: Wall-mount the switch with network ports facing up or down (away from or
toward the floor). Do not wall-mount the switch with the ventilation holes facing up or down.
(See "Installation and safety precautions" (page 3).)
Setting up the switch 5