Overheat Protection; Overdischarge Protection - Makita DF001D Instruction Manual

Connect the USB cable to the AC adapter, and then
plug the AC adapter into the mains supply. Open the
connector cover on the tool, and then connect the USB
cable to the connector.
Before the first use, be sure to charge the built-in bat-
tery. It takes approximately 3 to 5 hours to fully charge
the battery. The charging time varies depending on the
usage conditions and remaining battery capacity.
Unplug the USB cable from the tool, and then close the
connector cover.
NOTE: While charging, the built-in battery and AC
adapter may become warm. This is normal and will
continue until the built-in battery is fully charged and
the AC adapter has been disconnected from the
mains supply.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to
the motor to extend tool and battery life. The tool will
automatically stop during operation if the tool is placed
under one of the following conditions:

Overheat protection

When the tool is overheated, the tool stops automati-
cally. In this situation, let the tool cool before turning the
tool on again.

Overdischarge protection

When the battery capacity is not enough, the tool stops
automatically. In this case, charge the battery.
Switch action
B
To start the tool, simply push the switch on the A side
for the clockwise rotation and the B side for the counter-
clockwise rotation. Release the switch to stop.
CAUTION:
rotation before operation.
NOTICE:
Change the direction only after the tool
comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the tool.
Lighting up the front lamp
CAUTION:
source of light directly.
To turn on the light, press the lamp switch. To turn off
the light, press the lamp switch again.
ASSEMBLY
Installing or removing driver bit
A
To install a driver bit, push it firmly into the driver bit
holder. To remove the driver bit, pull it out of the driver
bit holder.
5 ENGLISH
Always check the direction of
Do not look in the light or see the