Sewing Light; Oil The Machine - Janome 2200XT Instruction Manual

Sewing Light

The sewing light is located behind the face plate.
To change the bulb, take the face plate off the
sewing machine by removing the setscrew.
Unplug the power supply before changing the
•
bulb.
' Do not dismantle the machine other than
explained in this manual.
(A) To remove .... Turn to the left.
To replace .... Turn to the right.
To remove .... Push and twist to the left.
(B)
To replace .... Push and twist to the right.
_&WARNING
The bulb could be HOT. Protect your
fingers when handle it.

Oil the Machine

Turn off the power switch and/or unplug
Note:
the machine before oil the machine.
Oil the points as shown at least once a year.
Use good quality sewing machine oil.
One or two drops of oil is sufficient.
Remove excess oil, otherwise it may stain fabric.
In case machine is not used for an extended time,
oil it before sewing.
Oil behind the face plate
Remove the screw and face plate.
Oil the point as indicated in the illustration.
CD Screw
CV
Face plate
Oil behind the shuttle hook area
Open the hook cover.
Remove the shuttle race ring and shuttle.
Oil the point as indicated in the illustration.
Q)
Hook cover
@
Shuttle race ring
®Shuttle
26