Operation - Makita DUR184L Instruction Manual

To reduce the risk damaging the objects in front of the
cutting head, insert the wire guard so that it controls the
cutting range of the mowing line.
Slightly expand the wire guard outward and then insert
it into the holes of the protector.
► 1 . Wire guard
NOTE: Do not expand the wire guard outward too
much. Otherwise it may break.
When wire guard is not in use, lift it for the idle position.
Installing nylon cutting head
Optional accessory
tally impacts a rock or hard object during oper-
ation, stop the tool and inspect for any damage.
If the nylon cutting head is damaged, replace it
immediately. Use of a damaged cutting tool could
result in serious personal injury.
wrench after installation.
NOTICE:
cutting head.
1.
the cutting tool easily.
2.
motor housing and rotate the receive washer until it is
locked with the hex wrench.
3.
spindle directly and tighten it by turning it clockwise.
4.
To remove the nylon cutting head, turn it counterclock-
wise while holding the receive washer with the hex
wrench.
1
► 1 . Nylon cutting head 2. Metal guard 3. Receive

OPERATION

Correct handling of tool
right-hand side. Correct positioning of the tool allows
for maximum control and will reduce the risk of seri-
ous personal injury caused by kickback.
control of the tool at all times. Do not allow the
tool to be deflected toward you or anyone in the
work vicinity. Failure to keep control of the tool
could result in serious injury to the bystander and the
operator.
11 ENGLISH
CAUTION:
If the nylon cutting head acciden-
CAUTION:
Make sure to remove the hex
Be sure to use genuine Makita nylon
Turn the tool upside down so that you can replace
Insert the hex wrench through the hole on the
Place the nylon cutting head onto the threaded
Remove the hex wrench.
4
washer 4. Hex wrench
WARNING:
Always position the tool on your
WARNING:
Be extremely careful to maintain
1
2
3