Installing The Guard; Operation - Makita UR014G Instruction Manual

5. Attach the spool to the spool holder, and then set
both sides of the nylon cord to the eyelets of the spool
holder. Attach the spool cover to the spool holder.
1
2
Fig.19
► 1. Spool 2. Spool holder 3. Eyelet 4. Spool cover
6. Remove the hex wrench from the gear case.
Correct combination of the cutting
tool and the guard
CAUTION:
Always use the correct combina-
tion of cutting tool and the guard. A wrong combi-
nation may not protect you from the cutting tool, flying
debris, and stones. It can also affect the balance of
the tool and result in an injury.
Cutting tool
Nylon cutting head
Attach the guard to the clamp using bolts.
3
4
Fig.20
► 1. Clamp 2. Guard 3. Cutter
Guard
16 ENGLISH

Installing the guard

WARNING:
Never use the tool without the
guard illustrated in place. Failure to do so can
cause serious personal injury.
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
2

OPERATION

Attaching the shoulder harness
WARNING:
Be extremely careful to maintain
control of the tool at all times. Do not allow the
tool to be deflected toward you or anyone in the
work vicinity. Failure to keep control of the tool
could result in serious injury to the bystander and the
operator.
CAUTION:
Always use the shoulder harness
attached to the tool. Before operation, adjust the
shoulder harness according to the user size to
prevent fatigue.
CAUTION:
Before operation, make sure that
the shoulder harness is properly attached to the
hanger on the tool.
CAUTION:
When you use the tool in combi-
nation of the backpack-type power supply such
as portable power pack, do not use the shoulder
harness included in the tool package, but use the
hanging band recommended by Makita.
If you put on the shoulder harness included in the
tool package and the shoulder harness of the back-
pack-type power supply at the same time, removing
the tool or backpack-type power supply is difficult in
case of an emergency, and it may cause an accident
or injury. For the recommended hanging band, ask
Makita Authorized Service Centers.
1
3