Specifications - Verizon V100 User Manual

V100_V100AM / USA EN / A31008-M1908-R301-1-6019 / appendix.fm / 12.3.08
Appendix
The incoming call number is not displayed
although CID is set.
Caller ID is not enabled.
¥
The caller must ask the network provider to
activate Caller ID (CID).
You hear an error tone when keying an
input.
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions, if necessary.
You cannot listen to messages left on the
network mailbox.
Your phone system is set for pulse dialing.
¥
Set your phone system to tone dialing.
The calls list does not indicate the correct
time messages were received.
The date/time is not set.
¥
Set the date/time (page 9).
You hear an error beep from the answer
machine during remote operation.
The system PIN entered is incorrect.
¥
Enter the system PIN again.
You cannot operate the answer machine via
remote operation.
Remote Access is not activated.
¥
Activate Remote Access (see page 20)
The answer machine does not record mes-
sages/has switched to "announce only".
Its memory is full.
¥
Delete old messages.
¥
Play back new messages and delete.

Specifications

Recommended batteries
Nickel-metal hydride (NiMH):
The handset is supplied with the author-
ized AAA batteries.
28
Handset operating times/charging
times
Capacity 550 mAh
Standby time Approx. 130 hours
(5.5 days)
Talk time Approx. 10 hours
Charge time Approx. 10 hours
The operating and charge times apply only
when using the recommended batteries.
Base station power consumption
In standby mode: approx. 1.5 watts
During a call: approx. 2 watts
General specifications
DECT 6.0 is supported
No. of channels 60 duplex channels
Radio frequency
range 1920–1930 MHz
Duplex method Time multiplex, 10 ms
frame length
Channel grid 1728 kHz
Bitrate 1152 kbit/s
Modulation GFSK
Language code 32 kbit/s
Transmission 10 mW, average power per
power channel
Range up to 984 feet outdoors,
up to 165 feet indoors
Base station
power supply 110 V ~/60 Hz
Environmental +41°F to +113°F;
operating condi-
20% to 75% relative
tions
humidity
Dialing mode DTMF (tone dialing)/DP
(pulse dialing)