Appendix; Care; Contact With Liquid; Questions And Answers - Verizon V100 User Manual

V100_V100AM / USA EN / A31008-M1908-R301-1-6019 / appendix.fm / 12.3.08

Appendix

Care

¤
Wipe the base station and handset with
a damp cloth (do not use solvents) or
an antistatic cloth.
Never use a dry cloth. This can cause
static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Immediately switch the handset off
and remove the batteries.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the hand-
set, with the battery compartment
open and the keypad facing down, in a
dry, warm place for at least 72 hours
(not in a microwave oven, convection
oven, etc.).
4. Do not switch on the handset again
until it has completely dried.
When it has fully dried, you should be able
to use it again normally.

Questions and answers

If you have any questions about the use of
your telephone, you can contact us at any
time at
http://www.verizon.com
The table below (page 27) contains a list
of common problems and possible solu-
tions.

Troubleshooting

The display is blank.
1. The handset is not switched on.
2. The batteries are empty.
The handset does not respond to a key press.
The keypad lock is activated.
¥
!
Base Search
screen.
1. The handset is outside the range of the base
2. The handset has been de-registered.
3. The base station is not switched on.
Handset does not ring.
The ring tone is switched off.
¥
You cannot hear the ring tone/dialing tone.
Base station's phone cord has been replaced.
¥
¥
3
2
1
The other party cannot hear you.
You have pressed the
set is on hold.
¥
¥
a
Press and hold the End Call key.
¥
Charge or replace the batteries (page 8).
Press and hold the pound key
(page 11).
Ä
and is flashing on the display
station.
¥
Reduce the distance between handset/
base station.
Register is flashing on the display screen.
¥
Register the handset (page 22).
¥
Check the base station power cord
(page 8).
Activate the ring tone (page 25).
When purchasing a new cord, make sure
that it has the correct pin connections.
Correct phone jack assignment
4
5
6
i
(INT) key. The hand-
Switch the microphone on again (page 1).
Appendix
#
Please
1 unused
2 unused
3 a
4 b
5 unused
6 unused
27