Sony XDR-S100CD Service Manual page 2

XDR-S100CD
General
Time display
24-hour system
Speaker:
1 ⁄ 8
Approx. 7.7 cm (3 in) dia. 6 :
Power output:
3 W + 3 W (at 10 % harmonic distortion)
Output:
i (headphones) jack (I 3.5mm stereo mini jack)
LINE OUT jack (I 3.5mm stereo minijack)
Input:
AUDIO IN jack (I 3.5mm stereo minijack)
Power requirements:
9 V DC, six R14 (size C) batteries
External power source:
DC IN 9 V
Dimensions:
Approx. 339 u 200 u 158 mm (w/h/d)
3 ⁄ 8 u 7 7 ⁄ 8 u 6 1 ⁄ 4
(Approx. 13 in) incl. projecting parts
and controls
Mass:
Approx. 3.8 kg (8 lb 6 oz) not incl. batteries
Supplied accessories:
AC power adaptor (1)
Remote control (1)
Design and specifi cations are subject to change without
notice.
SAFETY-RELATED COMPONET WARNING!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
2
WITH SONY PARTS
NOTES ON CHIP COMPONENT REPLACEMENT
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
NOTES ON THE AC POWER ADAPTOR
• When operating the unit with the internal batteries, remove the
AC power adaptor from the wall outlet and the DC IN 9 V jack.
Make sure that the plug of the external power source is discon-
nected before operating the unit.
• Use the supplied Sony AC power adaptor only. The polarity
of the plugs of other manufacturers may be different. Failure
to use the supplied AC power adaptor may cause the unit to
malfunction.