Entering And Exiting The Adjustment Pro Cess Mode - Sharp LC-37SD1E Service Manual

LC-37SA1E/RU
[3] Entering and exiting the adjustment process mode
1) Unplug the AC power cord of running TV set to force off the power.
2) While holding down the "VOL (-)" and "INPUT" keys on the set at once, plug in the AC power cord to turn on the power.
The letter appears on the screen.
K
3) Next, hold down the "VOL (-)" and "P(
Multiple lines of orange characters appearing on the screen indicate that the set is now in the adjustment Process mode.
If you fail to enter the adjustment process mode (the display is the same as normal startup), retry the procedure.
4) To exit the adjustment process mode after the adjustment is done, unplug the AC power cord to force off the power. (When the power is turned off
with the remote controller, once unplug the AC power cord and plug it in again. In this case, wait 10 seconds or so before plugging.)
Caution: Use due care in handling the information described here lest the users should know how to enter the adjustment process mode.
If the settings are tampered with in this mode, unrecoverable system damage may result.
[4] Remote controller key operation and description of display in adjustment process mode.
1. key operation
Remote controller key
P ( / )
(+ / –)
Cursor ( / )
Cursor ( / )
on remote controller
OK
* Input mode is switched automatically when relevant adjustment is started so far as the necessary input signal is available.
2. Description of display
(1) Current page/Total pages (3) Currently selected input
(2) Current page title
[INFO]
1/11
Main Version
Dev Version
Dev Loader Version
Pic Version
TEMP SENSOR
NORMAL STANDBY CAUSE
ERROR STANDBY CAUSE
)" keys on the set at once.
Main unit key
P ( / )
(+ / –)
——————
——————
button
——————
TV
LEW05 01.XX (XX/XX/XXX)
XX
XX
XX
XX
XX
XX
Moving an item (line) by one (UP/DOWN)
Changing a selected item setting (+1/–1)
Turning a page (PREVIOUS/NEXT)
Changing a selected line setting (+10/–10)
Input source switching (toggle switching)
(TV→EXT1→EXT2→EXT3→EXT4→EXT5)
Executing a function
(4) Current colour TV system
(5) Destination
AUTO AUTO:EURO
3 – 19
Function
Adjustment process
menu header
(7) Parameters