Limits; Starting Position; Park Action - Abus IPCS82500 User Manual

Tab: Pattern:

7.5.7.3 Limits

Setting to limit the pan and tilt (not zoom) area, e.g. to ensure that private areas are not viewed
Enable limitation:
Type of limitation:
Type status:
Set:
Delete:

7.5.7.4 Starting position

Note: the starting positon must be saved as any preset in advance.
Setting for the starting position of the PTZ Dome after restarting
Set: Set the current position as the starting position.
Delete: Delete the current starting position.
Go to: Retrieve a preset (preset position).

7.5.7.5 Park action

Function for performing a certain action after a defined amount of time (5–720 seconds)
Enable park action:
Park time:
start-up of this patrol step. Add further patrol steps as
required. When you are finished, press the disk symbol to
save the whole patrol. The playback symbol starts the patrol.
The stop symbol stops the patrol.
A pattern is a programmed control and zoom sequence. Here,
the camera stores all actions carried out by you using the
control and zoom keys. The configuration (learning phase) is
started by pressing the pencil symbol. The learning phase is
stopped by pressing the key to the right of the pencil symbol.
Enable the function.
Manual stops: limit manual control.
Search stops: limit scan actions.
Display whether a limitation has been set.
Clicking on this will initiate the process for setting the limitation
(see preview, one after the other: left, right, upper, lower
limitation, iris/aperture + button for saving)
Delete all limitations.
Enable the function.
This is the amount of time that must pass after manual PTZ control before
the park action function can be re-enabled (5–720 seconds).
106