Sony DSR-2000 Service Manual page 281

Replacement
1. Removing the MD cover
Remove the MD cover. (Refer to Section 7-2.)
2. Removing the MIC assembly
Remove the MIC assembly.
(Refer to Section 7-19.)
3. Replacing the MIC holder
subassembly
(1) Remove the portion A shown of the flexible
card wire from the MIC arm assembly as
shown in the figure.
(2) Remove the two stop washers from the back
side of the MIC assembly and remove the
MIC holder assembly.
(3) Fix a new MIC holder assembly to the MIC
assembly with two new stop washers (1.2).
n
Use great care not to fold and not to scratch
the flexible card wire when reattaching.
(4) Fix the flexible card wire to the MIC arm
assembly as shown in the figure.
(5) Insert a tip of the flexible card wire of the
MIC assembly between the chassis and the
front MD chassis to bring it to the back side
of the unit.
n
Use extreme care not to fold and not to
scratch the flexible card wire at this opera-
tion.
4. Reattaching the MIC assembly
Reattach the MIC assembly.
(Refer to Section 7-19.)
5. Reattaching the MD cover
Reattach the MD cover. (Refer to Section 7-2.)
DSR-2000/2000P
Flexible card wire
A
Stop washer
MIC arm assembly
Flexible card wire
MIC arm assembly
7-20. MIC Holder Assembly Replacement
MIC holder assembly
Stop washer
7-59