Sony DSR-2000 Service Manual page 137

Removal/Reattachment of the HP-99 board
(1) Remove the control panel. (Refer to Section 3-3.)
(2) Lift up the right/left hinge levers in the arrow direction
and bring the control frame assembly to the lateral
position, then loosen the two screws (PWH3 x 6).
(3) Disconnect the flexible card wire form the connector
(CN710) of the KY-452 board.
Control frame assembly
Screw
PWH3 x 6
Flexible card wire
Control frame assembly
Hinge lever
DSR-2000/2000P
CN710
Screw
PWH3 x 6
(4) Slide the control frame assembly in the arrow direction
to remove it.
(5) Remove the screw and release the two claws form the
rear side of the assembly and remove the KY cover.
(6) Disconnect the harness from the connector (CN2) of
the HP-99 board.
(7) Remove the two nuts to remove the HP-99 board.
n
Support the HP-99 board from the rear side when
removing the nuts.
(8) Reattach the HP-99 board in the reverse order of the
removing steps (1) to (7).
CN2
HP-99 board
Harness
Claw
KY cover
3-5. Removal/Reattachment of the Boards
Control frame assembly
Claw
Screw
PWH3 x 6
3-21