Input Voltage Selector Switch - Tesla TI50A User Manual

2
Product Overview
2.11 – Input Voltage Selector Switch
The Input Voltage Selector Switch allows the unit to operate safely within the expected voltage range of either
100 - 130 Vac or 200 - 260 Vac.
Changing Input Voltage Selector Switch
To change the input voltage from 115 Vac to 230 Vac, simply follow these steps:
1. With cross tip screwdriver, remove one screw and rotate the clear protective cover to one side.
(see figure2.11.2)
2. Flip the switch to read 230V. (see figure 2.11.3)
3. Rotate cover back into place. Replace and tighten screw.
!
CAUTION
!
NOTE
Figure 2.11.2 - Unscrew Protective Cover
!
NOTE
10
Figure 2.11.1 Input Voltage Selector Switch
Do not plug unit into 230 Vac when Input Voltage Selector Switch is
set on 115 Vac.
The 115 Vac setting accommodates the voltage range of 100-130 Vac.
The 230 Vac setting accommodates the voltage range of 200-260 Vac.
Do not overtighten Selector Shield screws. Be sure star locks are on
screws and snug the screw. Overtightening will damage the Selector
Shield.
(outlined in blue)
Figure 2.11.3 - Select Voltage
TI50A DC Power Supply