GE enFlow IV Operator's Manual page 12

Controller Display
The Controller display continuously reflects the specific infusate temperature that the Warmer
monitors and maintains.
The various readouts that may be depicted on the Controller display are described in the following
tabulation:
Table 1: Controller Display: Normal Operating Model
Activity
Warmer is connected and power is
engaged.
Warmer is not connected, but
Controller is powered on.
Warmer is connected, but covers
are open on Warmer.
Warmer is connected, and covers
are either open or closed on
Warmer; however, disposable is not
in Warmer.
Table 2: Controller Display: Alarm Mode
Activity
Warmer Over Temperature
Mute button activated.
Fault detected
Table 3: Controller Display: Setup Mode
Activity
While powering up the Controller,
hold the center button down until
the clock screen is displayed. Then,
use the buttons to set the clock.
4400-0024 enFlow Operator's Manual EN Rev. T 05/12
Display Reads
Temperature and Clock
40 °C
9:00 A
Not Heating
Not Heating
Not Heating
Display Reads
Display alternates between
Over Temp and
Press Key to Mute
Over Temp
Muted
System Fault XX
If a system fault message is
on the Controller display,
contact Technical Support.
Display Reads
09:00 A
Display Color and
Function
Identical to Warmer
Temp LED
Yellow
Yellow
Yellow
Display Color and
Function
Identical to Warmer
Temp LED
Identical to Warmer
Temp LED
Red
High Priority Alarm
Display Color and
Function
Blue
Page 12 of 26