Name Of Parts; Basic Operations - JVC RM-LP100U Instructions Manual

Name of Parts

Front panel
A
B
C
D
E
.
A USER1 button
For switching the settings menu.
B F1 knob
Used for the multi-function settings.
C F2 knob
Used for the multi-function settings.
D USER2 button
For switching the settings menu.
E Zoom lever
For performing the zoom operation of the remote camera.
F ALARM lamp
Red : Lights up when the alarm is activated.
G POWER lamp
Green : Lights up while the power is on.
H Control lever (F3)
0 For operating pan/tilt of the remote camera.
0 Used for the multi-function settings.
I Focus knob/Push auto button
0 For performing the focus operation of the remote camera.
0 Used for the one-push auto focus function.
J Operation panel
Used as a touch panel.
Rear panel
A B C D E
I
.
A Power switch
For turning the power on or off.
B Cable clamp
For preventing the AC adapter cable from falling out.
C DC 12V terminal
For connecting the supplied AC adapter.
F
G
H
I
J
F G H
D LAN terminal
For connecting a LAN cable.
E SERVICE terminal
For use during servicing.
F TALLY terminal
Used for TALLY connection.
G SETTING switch
1 to 4 : For switching TALLY IN and OUT.
5 to 8 : Used for servicing only.
H SERIAL terminal
Not used.
I Rating label

Basic Operations

For details, refer to the instruction manual.
1 Turn on the power.
0 Set the power switch at the rear of this unit to "On". The
LED lamp lights up in green.
2 Configure the settings of this unit.
0 Set the IP address of this unit as follows.
A Select [SETTINGS] on the top screen of the control
panel.
0 If the top screen doesn't appear, select [HOME].
B Select [Network].
C Select [CONTROLLER].
0 The IP address setting screen appears.
D Enter the IP address and press [ENTER].
3 Configure the camera setting.
0 Set the camera to be operated as follows.
A Select [SETTINGS] on the top screen of the control
panel.
0 If the top screen doesn't appear, select [HOME].
B Select [Network].
C Select [CAMERA REGISTRATION].
D Select [AUTO] to register the camera.
Memo :
0 For details on the [MANUAL] settings, please refer
to the "INSTRUCTIONS" on the website.
0 To change the camera to be operated, perform the above
operations again.
9
Name of Parts