Getting started
Wall mount installation
1. Make sure the telephone line cord is unplugged from the modular jack and the
power adapter cord is unplugged from the electrical outlet before installation.
2. Remove the base bracket by lifting it up from both sides of the bracket as shown in
the illustration below.
3. Slide the wall mounting switch to the wall position as shown in the illustration
below.
desk
wall
desk
wall
6
Getting started
4. Route the telephone line cord through the channel as shown below, leaving about
2 inches from the end of the channel for plugging into the wall jack as shown in
illustration below.
5. Plug the telephone line cord into the jack on the wall plate. Align the holes on the
telephone with the mounting studs of the wall plate and slide the telephone base
down until it locks securely. Tie the excess cords neatly with a twist tie. Plug the
power adapter into an electrical outlet as shown below. Be sure to avoid using an
electrical outlet that is controlled by a wall switch.
desk
wall
desk
wall
7