Table of Contents
Advertisement
Make sure that all the test leads are
disconnected with the meter's terminal for
current measurement.
1. Select "~A" range.
2. Open the clamp and put the tested conductor in the
center of the clamp jaws (See Fig.4).(No gap is
allowed between the connections of clamp jaws)
3. The current value will be indicated on the LCD.
4. If the reading is difficult, press the DATA HOLD
button to hold the obtained value. To exit from this
function press DATA HOLD button again.
Fig.(4)Use of the clamp during AC current
4.3. AC VOLTAGE (ACV) MEASUREMENT
measurement
CAUTION
W
EN-9
TM-1012
A
RNING
Advertisement
Table of Contents
