Sim Card And Battery Installation; Sd Card Installation - Nordmende LITE110B User Manual

SECTION 3
GETTING STARTED

1 SIM CARD AND BATTERY INSTALLATION

A SIM card carries useful information, including your mobile
phone number, PIN (Personal Identification Number), PIN2,
PUK (PIN Unlocking Key), PUK2 (PIN2 Unlocking Key), IMSI (In-
ternational Mobile Subscriber Identity), network information,
contacts data, and short messages data.
Note: After powering off your mobile phone, wait for a few
seconds before removing or inserting A SIM card.
Exercise caution when operating A SIM card, as friction or
bending will damage the SIM card.
Properly keep the mobile phone and its fittings such as the
SIM cards beyond children's reach.
■ Hold the End key for a while to power off the mobile phone.
■ Push the back cover above the battery and remove it.
■ Pull the left battery buckle outward and then lift the battery
away.
■ Insert the SIM card into the SIM card slot lightly with the
corner cutting of the card aligning to the notch of the slot
and the gold plate of the card facing download, till the SIM
card cannot be further pushed in.
■ With the metallic contacts of the battery facing the metallic
contacts in the battery slot, press the battery down until it
locks into place.

2 SD CARD INSTALLATION

The T-Flash card is a pluggable mobile storage card inside the
mobile phone. To install the T-Flash card, open its latch, place
its indented side downward, insert the card into the card slot,
and then close the latch.
USER GUIDE | page 12