Removal/Reattachment Of The Cassette Compartment - Sony DSR-1800 Service Manual

3-4. Removal/Reattachment of the Cassette Compartment

3-4. Removal/Reattachment of the
Cassette Compartment
Removing
(1) Remove the top panel. (Refer to Section 3-3.)
(2) Disconnect the flexible card wire from the connector
(CN1) of the CC-83 board.
(3) Remove the three screws and lift off the cassette
compartment holding assembly in the arrow A direction.
(4) Remove the cassette compartment straight upwards.
Cassette compartment retainer assembly
Fixing screw
CC-83 board
Cassette compartment
Frexible card wire
Positioning pin
3-12
CN1
Positioning
pin
Reattaching
(1) Insert the cassette compartment straight downwards,
and align the three holes and notch to the four posi-
tioning pins of the chassis.
n
Use care not to involve a lead wire of the reel shift
motor when reattaching the cassette compartment.
(2) Insert the cassette compartment holder assembly in the
reverse direction of the arrow, pass the holes and notch
through the a and b axes of the cassette compartment,
and secure with the three screws. At this same, align
the c and d parts of the cassette compartment holder
assembly to holes e and f of the chassis, and tighten
with screws.
(3) Reconnect the flexible card wire to the connector
(CN1) of the CC-83 board.
(4) Reattach the top panel. (Refer to Section 3-3.)
Fixing screws
d
c
b
a
f
e
Chassis
Positioning pins
DSR-1800/P/1600/P