Sony DSR-1800 Service Manual page 289

Replacement
1. Removing the frame assembly, MD
Remove the frame assembly, MD.
(Refer to Section 7-2 Step 1.)
2. Disconnecting the flexible card wire
Disconnect the flexible card wire from the
connector (CN16) on the DR-428 board located
on the back side of the MD chassis.
3. Moving the S/T reel tables
Turn the reel shift motor gear in the arrow
direction by the bamboo skewer and bring the S/T
reel tables to the standard cassette position (the
most front side).
4. Removing the L push plate
Remove the L push plate. (Refer to Section 7-3.)
5. Removing the MIC spring
Unhook the hooks on the both ends of the MIC
spring which hold the MIC arm and the RLR
assemblies.
DSR-1800/P/1600/P
MIC assembly
flexible card wire
DR-428 board
S reel table
RLR assembly
MIC spring
7-19. MIC Assembly Replacement
Connector (CN16)
T reel table
MIC assembly
Reel shift
motor gear
7-55