Table of Contents
Advertisement
3.1.2 Removing the top cover
(See Figs.3 and 4)
• Remove the side covers.
(1) From the rear side of the main body, remove the screw C
attaching the top cover. (See Fig.3.)
(2) From the both side of the main body, remove the two
screws D attaching the top cover. (See Fig.4.)
(3) Remove the top cover in the direction of the arrow. (See
Fig.4.)
3.1.3 Removing the front panel assembly
(See Fig. 4)
• Remove the top cover and side covers.
(1) From the right side of the main body, disconnect the card
wire from the connector
board.
(2) From the both side of the main body, release the claws a of
the front panel assembly and then remove the front panel
assembly.
3.1.4 Removing the tuner
(See Figs.4 and 5)
• Remove the top cover and side covers.
(1) From the right side of the main body, disconnect the card
wire from the connector
Fig.4.)
(2) Remove the two screws E attaching the tuner to the rear
panel. (See Fig.5.)
3.1.5 Removing the heat sink
(See Figs.5 and 6)
• Remove the top cover and side covers.
(1) From the rear side of the main body, remove the screw F
attaching the rear cover. (See Fig.5.)
(2) Release the joint sections b and remove the rear cover.
(See Fig.6.)
(3) Remove the two screws G and four screws H attaching the
heat sink. (See Fig.6.)
(4) Remove the heat sink from the rear panel.
CN400
and
CN401
on the micon
CN405
on the micon board. (See
C
Top cover
Fig.3
D
Top cover
a
CN400
CN401
Fig.4
F
E
Fig.5
Rear panel
Heat sink
H
b
H
b
Fig.6
Tuner
CN405
Micon board
Rear cover
b
G
b
(No.MB522)1-9
Advertisement
Chapters
Table of Contents
