JVC UX-G33B Service Manual page 11

3.1.9 Removing the power supply board and power transformer
(See Figs. 10 and 11)
• Remove the top cover, side covers, tuner, heat sink, rear pan-
el, micon board and power amplifier board.
(1) From the top side of the main body, disconnect the power
cord connector CN900
(2) Remove the three screws P attaching the power transform-
er from the main body. (See Fig.10.)
(3) From the left side of the main body, remove the screw Q
and then remove the trans board and power transformer.
(See Fig.11.)
3.1.10 Removing the DVD mechanism assembly
(See Fig. 12)
• Remove the top cover, side covers, front panel assembly, tun-
er, heat sink, rear panel, micon board and power amplifier
board.
From the top side of the main body, remove the screw R attach-
ing the DVD mechanism assembly and then remove the DVD
mechanism assembly from the bottom chassis.
on the trans board. (See Fig.10.)
Trans board
Power cord
Fig.10
Trans board
Q
Fig.11
DVD mechanism assmbly
Fig.12
CN900
P
R
(No.MB522)1-11