Schematic Diagrams - Samsung BD-P1000 Service Manual

11. Schematic Diagrams

11-1 SMPS (SMPS PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-2 Audio DAC (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-3 S5L3700 (Audio/ATA/PERI) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - -
11-4 S5L3700 (Flash/CS8900) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-5 S5L3700 (DDR Memory) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-6 S5L3700 (Video Out) (Main PCB)- - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-7 S5L3700 (Power/GND) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-8 DDR Termination (C) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-9 DDR Termination (A/B) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-10 ATA/ATAPI (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-11 S5L3700 (Video In) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-12 HDMI Out (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-13 Clock/Front Micom (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-14 DMN8602 (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-15 DMN8602 (DDR) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-16 DMN8682 (PERI) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-17 BCM7411A (DDR Sdram) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - -
11-18 BCM7411A (AVC Decoder) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - -
Samsung Electronics
11-2 11-19 BCM7411A (Ana/Dig Decoupl) (Main PCB) - - - - - - - - - - - - - - - - - - - - -
11-3 11-20 Power (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-4 11-21 BCM7411A (Ana/Dig Decouplir) (Main PCB) - - - - - - - - - - - - - - - - - - - -
11-5 11-22 FLI8638 (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-6 11-23 FLI8638 (DDR/Flash) (Main PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-7 11-24 Front (Front Key PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-25 Memory Caed (Memory Card PCB) - - - - - - - - - - - - - - - - - - - - - - - - - -
11-8
11-9 11-26 Power (Power Key PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-10 11-27 SUB (SUB PCB) - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
11-11
11-12
For schematic Diagram
- Resistors are in ohms, 1/8W unless otherwise noted.
11-13
Special note :
Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniques described under the
11-14
"electrostatically sensitive (ES) devices" section of this service manual.
11-15
Note :
Do not use the part number shown on this drawing for ordering. The correct part number is shown in the parts list (may be slightly
different or amended since this drawing was prepared).
11-16
Important safety notices :
11-17
Components identified with the mark
Use only the same type.
11-18
11-19
This Document can not be used without Samsung's authorization.
Note
have the special characteristics for safety. When replacing any of these components.
11-20
11-21
11-22
11-23
11-24
11-25
11-26
11-27
11-28
11-1