Yamaha DM2000 Orientation Manual page 6

Set Input Compressor
1. Select the channel
2. On SELECTED CHANNEL / DYNAMICS, press [COMP ON] button
if unlit.
3. On SELECTED CHANNEL / DYNAMICS, press [DISPLAY].
4. Keep pressing this button to locate "Compressor Library" page.
5. Recall program desired and edit if needed...
OR...
1. Select the channel.
2. On SELECTED CHANNEL / DYNAMICS, press [COMP ON] button
if unlit.
3. Press [GATE/COMP] to light [COMP] indicator.
4. Adjust [THRESHOLD] [RATIO] [ATTACK] [RELEASE] [GAIN] as
needed.
Set Input Equalization
1. Select the channel.
2. On SELECTED CHANNEL / EQUALIZER, press [EQ ON] button
if unlit.
3. On SELECTED CHANNEL / EQUALIZER, press [DISPLAY].
4. Keep pressing this button to locate "Equalizer Library" page.
5. Recall program desired and edit if needed...
OR...
1. Select the channel.
2. On SELECTED CHANNEL / EQUALIZER, press [EQ ON] button
if unlit.
3. Adjust [FREQUENCY] [Q] [GAIN] for each band as needed.
NOTE: [FREQUENCY] & [Q] toggle on same control by pushing the knob.
Output Channel Setup
≠
NOTE: Assume the output patch is completed.
Select the Output Channel
1. Press LAYER / [MASTER].
2. Select the output channel (bus master) by touching the fader.
3. If fader touch sensitivity is turned off, press [SEL].