Electrical Safety - Bella 6 Litre Pressure Cooker Instruction Manual

oatmeal and other cereals, noodles, pasta and rhubarb. Extra care should be taken
when cooking anything containing these.
17. Do not touch the pressure release valve when in use. Only turn to release
the pressure after the unit has finished cooking.
18. Ensure there is sufficient water in the removable cooking pot when steaming;
it should reach the minimum 1/5 mark at least.
19. Do not use the Pressure Cooker for Deep Frying.
20. Do not use metal utensils as they will scratch the premium non-stick coating
on the removable cooking pot. Use heat resistant plastic utensils or use
a wooden spoon.
21. Do not move the appliance when in use.
22. Always keep your hands and face away from the pressure release valve,
when releasing the pressure.
23. Use extreme caution when removing the lid after cooking. Always tilt the lid away
from you, so that any steam does not come into contact with your face.
24. To protect against electric shock, do not immerse the Pressure Cooker, base unit,
power cord or plug into water or any other liquid.
25. Unplug from the mains socket using dry hands when not in use and before
cleaning. Allow to cool before putting on or taking off parts.
Do not use the appliance for other than its intended use, this is for HOUSEHOLD USE
ONLY.

ELECTRICAL SAFETY

WARNINGS!
• Read these instructions thoroughly before using this appliance or connecting it to
the mains supply.
• A 13 amp BS1362 ASTA approved fuse must be fitted.
• This appliance must be earthed.
• There are no user-serviceable parts inside this appliance.
• Always refer servicing to qualified service personnel.
• The mains lead of this product is not replaceable by the user. If the mains
lead is damaged, do not use until the appliance has been inspected and approved
by a qualified electrician.
• Do not allow this product to be exposed to rain or moisture during use or storage.
Before switching on, make sure that the voltage of your electricity supply is the same
as that indicated on the product rating plate. Connecting it to any other power source
may cause damage.
This product may be fitted with a non-rewireable plug. If it is necessary to change
the fuse in the plug, the fuse cover must be refitted. If the fuse cover becomes lost or
damaged, the plug must not be used until a suitable replacement is obtained. If the
plug has to be changed because it is not suitable for your socket, or due to damage,
it should be cut off and a replacement fitted, following the wiring instructions shown.
The old plug must be disposed of safely because inserting it into a 13 amp socket could
cause an electrical hazard.
3