ZyXEL Communications P-2612HNU-Fx Series Quick Start Manual page 6

• The POWER light blinks during start-up and is green once the P-
2612HNU-Fx is ready.
• An ETHERNET light turns on if the corresponding ETHERNET port
is properly connected. An Ethernet port's light blinks when the P-
2612HNU-Fx is sending or receiving data through it.
• The WLAN light stays green when the wireless LAN is ready. It
blinks when the P-2612HNU-Fx is sending/receiving data through
the wireless LAN.
• The DSL light stays on if a physical DSL connection exists and
blinks when transmitting data.
The WAN light stays on if this port is properly connected and blinks
when transmitting data.
The INTERNET light is green when Internet access is available.
• The PHONE lights stay on when your SIP account is registered and
they blink if the receiver is off the hook.
• The USB light turns on when there is a USB device (printer or
memory stick) connected to the P-2612HNU-Fx and blinks when
transmitting data.
If no lights are on, check your connections. Make sure that
you have the power adaptor connected to the P-2612HNU-
Fx and plugged in to an appropriate power source. Make
sure the power source is turned on. Turn the P-2612HNU-Fx
off, wait for a few seconds and turn it back on. If the LEDs
are still off, contact your local vendor.
6