Using Usb Devices - Panasonic CF-45 Series Reference Manual

Using USB Devices

Installing USB Devices
1
Run the Setup Utility
2
Using and
3
Using and
Enter
4
Using and
5
Using and
6
Using and
7
Using and
8
Using and
9
Press , then select [Yes]
F10
10
Install the Windows 95 USB device drivers
1
In [Start] - [Run], input [c:\util\msupdate\usbsupp.exe]*, then press [OK].
At the confirmation message, press [Yes].
*
After reinstalling the hard disk, set the Windows 95 CD-ROM included in the Windows 95
System Pack and input [L:\other\updates\usb\usbsupp.exe].
2
Read the [END-USER LICENSING AGREEMENT] and press [Yes] or [No].
• Installation will start if [Yes] is pressed.
• Installation will be aborted if [No] is pressed.
3
At the display indicating the completion of installation, press [OK]. The computer
will automatically restart.
4
In [Start] - [Run], input [c:\util\msupdate\usbcopy.bat], then press [OK].
5
Click at the upper right corner to close the display.
6
In [Start] - [Settings] - [Control Panel] - [System] - [Device Manager], select [PCI
Universal Serial Bus] in [Other devices], press [Remove], then press [OK].
7
Press [Refresh] and press [Close] at the [System Properties],
8
Restart the computer,
CAUTION
After a driver has been installed, do not use the suspend or hibernation function. If
the suspend or hibernation mode is activated, the computer may not function prop-
erly. Power off, then on, using the power switch to resume proper operation.
If you want to use the suspend or hibernation function when the USB driver is
installed, disable the USB device function of the computer. (
( page 26)
, select [Power]
, select [Power Management] and press
, select [Disable] and press
, select [Power Switch] and press
, select [Off] and press
, select [Fn+F7/Fn+F10 key] and press
, select [Disable] and press
22
Enter
Enter
Enter
Enter
Enter
page 6)
(To next page)