Table of Contents
Advertisement
3.
First make sure the frame stands firmly, and then pull the module gently along the slot till out
of frame.
4.
Install the front panel.
Chapter 3 Operation and Control
Setting Jumper
There exist three 3-pin jumpers, and the following table gives their definition.
Item
JP4
(OUTPUT B SEL)
JP3
(OUTPUT A SEL)
JP2
(AUTO SWITCH)
LED Indicator
If setting JP2 at AUTO, input signal is auto-detected.
Set signal format by choose jumpers（540M,360M,270M,177M,143M）.
Note: please set only one option of the jumpers.
SRA6802N SD-SDI Dual Distribution Amplifier
Figure 3-1 Position of JP2、JP3 and JP4
Table 3-1 Description of JP2、JP3 and JP4
Description
IN1 output B choose the first video input
IN2 output B choose the second video input
IN1 output A choose the first video input
IN2 output A choose the second video input
ON
switch two inputs automatically
OFF two channel mode is set compulsorily
- 6 -
Advertisement
Table of Contents
