Table of Contents
Advertisement
Step2
Step3
Step 4
Step5
Locate the position for back connector and insert the back connector
Fasten the screw to fix the back connector.
Locate the slot for module.
Get the module installed in the slot, push the module slightly along the slot, press module again to
confirm that the module is installed firmly and then close swivel handle.
Install the front panel.
Signal Connections
All signal connections shall be made through the general bus of 6800N Series frame
Module Removal
Follow the following steps to remove VDA6800N module:
1.
Open the front panel
2.
Open the swivel handle to the full.
DEC/DES6800 CVBS/SDI Converter
Fig. 2-1 Installation of 2U Frame of 6800N Series
- 7 -
Advertisement
Table of Contents
