Appendix. Rs-232 Command Set; About The Command Set - Black Box AVSC-0802H User Manual

Appendix. RS-232 Command Set

1. Connect the matrix to a PC via a UART-to-USB cable.
2. Run the UART tool on the PC, and configure the serial port as described in the
following table.
NOTE: The data format is ASCII.
A.1 About the Command Set
Take Command SET SW in out[CR/LF] as an example:
1. [SET SW] denotes command keywords, not case-sensitive.
2. [in out] denotes parameters, not case-sensitive. In and out are different parameters,
and incorrect parameters will not be recognized.
3. [out 1] denotes HDBaseT OUT, [out 2] denotes HDMI OUT.
4. [CR/LF] is required at the end of all commands.
5. The space character is not case-sensitive.
Table 3-1. Serial port settings.
Serial Parameter Setting
Baud rate
Data bits
Parity bits
Stop bits
Flow Control
877-877-2269 | BlackBox.com
Appendix: RS-232 Command Set
57600 bps
8 bits
None
1 bit
None
Page 51