Table of Contents
Advertisement
Chapter 3: Pin Assignments and Wiring
3. Pin Assignments and Wiring
3.1 MIC IN
Connects to balanced microphone using the 3-pole, 3.5-mm captive screw connectors.
Wire as shown below:
Figure 3-1. MIC IN wiring.
3.2 Audio IN/OUT
The diagram below shows how to wire the captive screw audio connector. Insert the
wires into the appropriate openings in the direct insertion connector. Tighten the screws
on the side to fasten the wires.
Connect one end of a 5-wire audio cable to this 5-pole 3.5 mm direct insertion connec-
tor. Connect the free end of the same cable from the device to any compatibly wired
unit, such as an amplifier.
Figure 3-2. Audio IN/OUT wiriing.
Page 19
877-877-2269 | BlackBox.com
Advertisement
Table of Contents
