Philips 200WP7EB/00 Service Manual page 71

GENERAL PRODUCT SPECIFICATION
4.1 Test conditions
Unless otherwise specified, this specification is defined
under the following conditions.
(1) Input signal
(2) Luminance setting: controls to be set to 200 nits with
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 +/- 5 °C
4.2 Resolution:
Item H.Freq. Mode
(KHz)
1 31.469 IBM VGA 10H
2 31.469 IBM VGA 3H
3 31.469 IBM VGA 12H
4 35.000 MACINTOSH
5 37.500 VESA
6 35.156 VESA
7 37.879 VESA
8 46.875 VESA
Note: 1. Screen displays at 40 preset modes
2. Screen displays perfect picture at 15 factory-preset modes
3. Screen displays visible picture with OSD warning when input modes
are other then 22 preset modes
4.3 Brightness: >=300 nits (at panel color temperature, at center of the screen, set contrast
20.1" TFT UXGA LCD Monitor
(HUDSON 7-200WP7)
TYPE
2006-02-16
BRAND : PHILIPS
Jason Wang
: As defined in 3.3, 1600x 1200
non-interlaced mode (75K/60Hz), signal
sources must have 75 ohm output impedance.
full screen 70 % duty cycle white signal
Factory preset modes (15 modes)
Resolution V.Freq.
(Hz)
640x350 70.086
720x400 70.087
640x480 59.940
640x480 67.000
640x480 75.000
800x600 56.250
800x600 60.317
800x600 75.000
: 200WP7ES/00
2006-02-16
Item H.Freq. Mode
(KHz)
9 48.363 VESA
10 60.023 VESA
11 68.700 MACINTOSH
12 63.981 VESA
13 79.976 VESA
14 75.0 VESA
15 65.29 -
8639 000 16908
25 590 15
71
200WP7 LCD
Resolutio V.Freq
n . (Hz)
1024x768 60.004
1024x768 75.029
1152x870 75.000
1280x102 60.020
4
1280x102 75.025
4
1600x120 60
0
1680x105 60.0
0