Zte ZXV10 W300 Quick Installation Manual page 36

ZXV10 W300 Quick Installation Manual
Problem
Use the Ping command to check if the network interface IP
address (preset to 192.168.1.1) of the device can be pinged
from the computer. If not, check the Ethernet cable connection.
Check if the indicator status is normal.
If the computer uses a private IP address (not a registered
illegal IP) specified manually, please check if the computer's
gateway IP address is an illegal address. If not, use a correct
gateway, or set the computer to obtain IP information
automatically.
PC unable to All the running firewall and VPN software have been closed.
access the The proxy server setting of the browser you use, e.g. IE, has
network been disabled.
Contact your ADSL Service Provider to confirm the DNS
server designated for the computer is valid. Otherwise, use the
correct DNS, or set the computer to obtain IP information
automatically.
Make sure you have set the NAT rule to convert the private IP
address into the legal address. The computer IP address you
specified must be contained in the range set in the NAT rule.
A problem may occur in the office-end device of the ADSL
Service Provider.
WLAN unable
Make sure the WLAN radio frequency is turned on and the
to be
WLAN indicator is ON.
connected
Unable to
Make sure the DNS server designated for the computer is
browse
correct. You can use the Ping command to check if the
Internet web
computer can be connected to the DSN server of the ADSL
pages on the
Service Provider.
computer
Statement:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
36
Troubleshooting