Table of Contents
Advertisement
NOTICE
All instructions, warranties and other collateral documents are
subject to change at the sole discretion of VolantexRC Co., Ltd..
Visit www.volantexrc.com for up-to-date product literature.
WARNING
The following terms are used throughout the product literature
to indicate various levels of potential harm when operating this
product.
CAUTION: Procedures, which if not be properly followed, is able to
create a possibility of physical property damage AND or possibility
of injury.
Read the ENTIRE instruction manual to become familiar
with the features of the product before operating. Fail to
operate the product correctly can result in damage to the
product, personal property and cause serious injury.
This is a sophisticated hobby product and NOT a toy. It must
be operated with caution and common sense and requires some
basic mechanical ability. Fail to operate this Product in a safe
and responsible manner could result in injury or damage to the
product or other property. This product is not intended for use
by children without direct adult supervision. Do not attempt
to disassemble , use with incompatible components or augment
product in any way without the approval of VolantexRC Co., Ltd..
This manual contains instructions for safety, operation and
maintenance. It is essential to read and follow all the instructions
and warnings in the manual, prior to assembly, setup or use, in
order to operate correctly and avoid damage or serious injury.
Age Recommendation:
Not for Children under 14 years. This is not a toy.
2
EXMITTER EX2 Digital Radio System
Advertisement
Table of Contents
Need help?
Do you have a question about the EX2 and is the answer not in the manual?
Questions and answers
My receiver does not respond to the bind plug. This joins the two outside connectors. The LED flashes about once a second. It's the same rate with bind plug fitted then powered on. The transmitter is turned on with bind button pressed and on releasing I hear several beeps. But nothing changes on receiver. I've tried 2 bind plugs. EX2 system with hand held controller. Help!
If your EXMITTER EX2 receiver does not respond to the bind plug and the LED flashes once a second, you should rebind the transmitter and receiver by following these steps:
1. Turn off the transmitter.
2. Insert the bind cable into the bind channel slot on the receiver.
3. Power on the receiver.
4. Within 5 seconds of powering on the receiver, turn on the transmitter while pressing the bind button.
5. Release the bind button and wait about 5 seconds.
6. Once the receiver stops blinking, binding is complete.
7. Remove the bind cable from the receiver.
Do not leave the bind cable inserted after binding is complete.
This answer is automatically generated