Nokia OZO camera Manual page 24

Preview with Oculus Rift DK2 Preview with Oculus Rift DK2
OZO Preview supports Virtual Reality Preview with an Oculus Rift DK2 headset.
Follow the headset setup instructions to use it with OZO Preview.
You can toggle the preview between your computer display and the headset with the HMD
button in the toolbar or the "View in HMD" command in the "View" menu.
Time: Playing, Pausing and Seeking Time: Playing, Pausing and Seeking
Basic playback controls are provided in the toolbar at the bottom of the window:
The "Stop" button sets the playhead to the beginning and stops the playback.
The "Play" button starts or resumes the playback of the file if stopped or paused. While playing,
it toggles into a "Pause" button, which pauses the playback.
The "Progress bar" allows to jump quickly into different times of the preview file.
The timestamp in the bottom toolbar provides info about the lenght of the preview file and the
current position of the playhead.
Arrow keys are used for fine control of the playhead. Left and right keys move playhead 1 frame
back and forward, while up and down keys move 1 second.
View Direction View Direction
You can change the viewing direction by panning the content of the preview window or by
moving the headset.
To go back to the 0-degree view at any moment, use the "Center View" command in the "View"
menu.
Midi Control Midi Control
Midi control can be used to start OZO Preview playback from digital audio workstations (DAW)
when they are running in different computers in the same network. This enables you to have
audio playback from DAW and video playback from OZO Preview in sync.
To use this feature with ProTools, first make sure "Network midi" is set up in "Audio Midi Setup"
in OS X preferences and that in OZO Preview "MTC Sync" command in "View" menu is enabled.
Then do the following in ProTools:
1 1 . . Set up your session ("Setup" > "Session") to start at 00:00:00:00.
2 2 . . In "Setup" > "Peripherals...", set the MTC Generator to be your network session.
3 3 . . Go to the next tab "Machine Control" and enable the master.