Nokia OZO camera Manual page 15

Introduction Introduction
OZO Remote is an application that allows you to remotely and wirelessly control the OZO Camera
and live preview captures. It is needed, for example, to set and monitor the exposure of the OZO
Camera.
The application is composed of two main areas:
The column on the left side of the window focuses on the connection, control and monitoring of
the Camera. It is composed of different panels that you can open and close at will depending on
your needs.
The big area on the right is focused on the preview of the SDI signal provided by the Camera.
The control of the Camera happens via Wi-Fi, while the preview is done via SDI cables. The
intended setup is to connect WiFi and SDI both to the same OZO Camera.
Connecting WiFi and SDI each to different Cameras is theoretically possible but not intended.
Please observe the application as it may appear dysfunctional with that setup.
OZO Remote is also used to format the OZO Media Module in the Camera.
Controlling the OZO Camera Controlling the OZO Camera
You can control the Camera with the panels located on the left side of the window. Different
elements are provided to connect, change the capture settings, capture and monitor the battery
and storage levels of the Camera.
Connecting to and Disconnecting from Camera via WiFi Connecting to and Disconnecting from Camera via WiFi
Make sure the OZO Camera is powered on and that your computer has Wi-Fi enabled. The
Camera will appear in OZO Remote in the panel of OZO devices. The panel includes both
currently available and previously connected Cameras.
R E M O T E R E M O T E