Nokia OZO camera Manual page 16

Click on the Camera in the panel to connect.
To disconnect, use the command "Disconnect" from the "Connection" menu.
The wireless range will depend on the operating environment, and is consistent with other Wi-Fi
802.11 systems, that is typically 50-200 ft (15-16-m).
Broadcasting and Standby Broadcasting and Standby
OZO Cameras can be in broadcasting or standby mode. In broadcasting mode, video is sent out
over SDI. In standby, the Camera is in low energy consumption mode and video is not sent out.
When the device is powered on, it is automatically set to broadcasting mode by default. To
switch between these modes, click on the Camera mode button.
Capturing Capturing
To start and stop capturing with the connected Camera, click on the Capture button in the
Camera Mode panel.
Captures will be stored in the internal SSD of the connected Camera.
Illuminant Setting Illuminant Setting
To set the illuminant of the connected Camera use the Illuminant control in the Capture Settings
panel.
This illuminant is set on the Camera and will be used while capturing. Alternatively, if you want to
change the illuminant only for preview purposes without affecting the Camera illuminant setting,
use the preview illuminant setting located in the monitoring area.
Exposure Setting Exposure Setting
To set the exposure of the connected Camera use the Exposure control in the Capture Settings
panel.
Power Status Power Status
To monitor the usage of the power, open the Power panel.
The Power panel indicates if the Camera is currently plugged to external power or using the
battery in the Digital Cartridge.
The panel provides the remaining battery level in any case, but observe that the battery gets re-
charged only with the OZO Docking Station.
Storage Storage