Advertisement
4
5
Note
• INPUT 2 must be higher than INPUT
1 when using CATV channels,
and INPUT
1 and INPUT
2 must be separated by at least one unused
channel.
• If the MRD-D1
is improperly
tuned, the power indicator will blink. Do
not ignore a blinking power indicator even if the TV is showing a
picture. Repeat the tuning procedure until the power indicator is
steady on.
Tune your TV to the channel
you selected
for INPUT
1. Turn on
the DSS receiver.
Using
the tuning
tool provided,
turn the first two rotary
controls
on the top of the modulator
unit to the channel
number
selected
in
step 3. Begin the tuning
process
by setting
the first digit of the
channel
with the first rotary
control,
and then the second
digit of'
the channel
with the second
rotary
control.
Tune only one channel
at a time.
MODULATOR
LINE 2
LINE 1
3
5
3
5
1 --_'_7
0 "_g
6
When
the channel
is selected,
the main TV should
be displaying
a
picture.
This confirms
proper
operation
and channel
tuning.
The
DSS channel
will now be available
on every TV connected
to the
system.
Repeat steps 4 and 5 using your second video source and your
selected
INPUT 2 number.
If there is no second
source, set INPUT
1.
12 Installation Instructions
Advertisement
