Table of Contents
Advertisement
3. Once it receives a signal from the baby unit, the visual level meter 17 will light up.
The number of segments being lighted up vary along with the sound. This feature is
useful in case the parents prefer to turn down the speaker volume to keep the
environment quiet.
4. The speaker volume can be adjusted using the
Each press of button will change the volume by 1 step which is correspondingly
indicated by the visual level meter 17 . There are total 5 volume levels, more
segments shown in visual level meter 17 means higher volume. When the volume
setting is at minimum, further press of
totally muted with the
5. This unit is equipped with a vibration alert. Press the
19 will show up. Once the received baby's voice is loud enough, the vibrator starts
to function. This feature is useful when the parent is working under noisy environ -
ment (e.g. vacuum cleaning). To save battery power, it is recommended not to use
the vibration alert frequently. To switch off vibration, press the
and the
icon 19 goes off.
6. Once this unit is beyond the communication range of baby unit for over 30 sec, an
out of range alarm will be heard together with segments of the visual level meter 17
flashing to alert the parents. The alarm sound is independent of whether the speaker
is muted or not. This alarm will go off only when the parent unit falls back within the
communication range of baby unit.
N.B. This alarm will also be heard in case the baby unit is switched off, or its
battery has run down, or its power is cut off, or the pairing is not properly done
between the baby and parent unit.
7. The condition of the Li battery pack is shown by the power on/low battery icon
When battery level becomes running low, the
be heard, reminding the parents to charge up the battery using the supplied AC
adapter.
8. Each time the buttons are pressed, a beep tone will be heard. To eliminate this beep
tone, press and hold the
To resume the beep tone, press and hold the
is heard. Whenever the unit is switched off and then on again, the beep tone will
resume automatically.
button 14 will cause the speaker 21 to be
icon 20 being lighted up.
button 14 for 2 sec until a second beep tone is heard.
9
button 14 and
button 16 and the
icon 18 turns red and an alarm will
button 15 for 2 sec until a beep tone
button 15 .
icon
button 16 again
18 .
Advertisement
Table of Contents
