Table of Contents
Advertisement
OPERATION
Baby unit
1. Long press the power ON/OFF button
power on icon
button
1 again.
2. Place the unit about 1 m from the crib with the microphone 11 facing towards the
baby.
3. Adjust the microphone sensitivity using the
that the unit will be set to transmit whenever the microphone 11 picks up a sound at
your desirable loudness level. The intensity of night light 6 will change during
adjustment. The higher the intensity, the more sensitive is the microphone 11 to
sound. There are total 5 levels of microphone sensitivity. When the maximum level
is reached, further press of the
sion mode (i.e. the unit will transmit even without detecting a sound) and the
icon 10 will light up steady green.
4. Once the unit is in transmit mode, the transmit icon
unit will return to standby mode a few seconds after the microphone 11 stops picking
up any sound and the transmit icon
continuous transmission mode, the transmit icon
5. The night light 6 can be set permanently ON by pressing the
press of
button 4 will increase the level of light intensity ( maximum 5 levels).
The night light 6 can also be set to VOX (voice activated) by pressing
5 . Under VOX mode, the
switched on once the microphone 11 detects a sound and automatically fade off a
few seconds after the sound stops.
5. The condition of the battery is shown by the power on/low battery icon
the battery level becomes running low, the power on/low battery icon
red. Replace with new battery or use the supplied AC adapter.
Parent unit
1. Long press the power ON/OFF button
power on icon
button
13 again.
2. Place this unit at a reasonable distance away from the baby unit to avoid feedback.
Too close a distance will create a screeching sound at the speaker 21.
7 should light up steady green. To turn off, long press the
button 3 will set the unit into continuous transmis -
icon
18 should light up steady green. To turn off, long press the
1 for 3 sec to switch on the unit. The
button 2 and
8 will go off. Except when the unit is set in
8 will stay steady on.
9 will light up and night light 6 will be
13 for 3 sec to switch on the unit. The
8
button 3 such
8 will light up green. The
button 4 . Each
7 . When
000
ON
button
7 turns
Advertisement
Table of Contents
