Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Bambi BC-62
- Page 1 Instruction Manual...
- Page 2 Thank you for purchasing our BC-62 baby monitor. Your unit has been manufactured and checked under the strictest possible quality control to ensure that each monitor leaves the factory in perfect condition. If in the unlikely event you find any defects or have any problem, please contact your dealer, our branch or service center.
- Page 3 WARNING The BC-62 baby monitor should not be regarded as a medical device. Premature babies or those considered to be at risk should be under the supervision of your doctor or health personnel. Direct supervision of your baby at a regular interval by a responsible adult is strongly recommended in addition to using the BC-62.
- Page 4 POWER SUPPY (A) Baby Unit Operation from batteries Pr ess down the lock button and slide open the battery door in direction as shown. Insert three pieces AAA size (UM-4) alkaline batteries into the compart - ment. Observe correct polarities indication. N.B.
- Page 5 (B) Parent unit 1. Operation from battery pack The Li polymer battery pack is already installed in the unit. To exchange battery pack, press and open the battery cover, remove the belt clip in the direction as shown, take out the battery pack and disconnect from socket. 2.
-
Page 6: Controls Layout
CONTROLS LAYOUT BABY UNIT PARENT UNIT Power On/Off button USB port Microphone Sensitivity Down adjustment button Power On/Off button Microhone Sensitivity Up adjustment button Volume down button Night Light intensity adjustment button Volume up button Night Light VOX control button Vibration button Night Light Visual level meter/Out-of-range icon... - Page 7 PAIRING This process is to match the parent unit with baby unit so that they can communicate with each other while no other devices (even baby monitor of identical model) can interfere with you or receiving your signal. The baby and parent unit are already paired with factory preset code when they are shipped from factory.
-
Page 8: Operation
OPERATION Baby unit 1. Long press the power ON/OFF button 1 for 3 sec to switch on the unit. The power on icon 7 should light up steady green. To turn off, long press the button 1 again. 2. Place the unit about 1 m from the crib with the microphone 11 facing towards the baby. - Page 9 3. Once it receives a signal from the baby unit, the visual level meter 17 will light up. The number of segments being lighted up vary along with the sound. This feature is useful in case the parents prefer to turn down the speaker volume to keep the environment quiet.
-
Page 10: Standard Accessories
- The BC-62 is best performed within a temperature range of -19˚C to +50˚C. - Do not open the cabinet, no serviceable parts inside. - The BC-62 should not be exposed to dripping, splashing and that no objects filled with liquids, such as vases shall be placed on it. -
Page 11: Troubleshooting Guide
TROUBLE SHOOTING GUIDE POSSIBLE CAUSE SOLUTION PROBLEM - Mic sensitivity is too low - Adjust mic sensitivity higher using Baby Unit button 3 has no - Battery has run down or AC - Replace with new battery or Transmission adapter improperly connected check connection - Mic Sensitivity is too high - Adjust mic sensitivity lower using... - Page 12 All European Countries except Austria, Georgia, Greece, Norway, Russian, Federation, Spain, Sweden, The Netheriands, Ukaine.
- Page 14 Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.