Bambi BC-62 Instruction Manual page 5

(B) Parent unit
1. Operation from battery pack
The Li polymer battery pack is already installed in the unit. To exchange
battery pack, press and open the battery cover, remove the belt clip in the
direction as shown, take out the battery pack and disconnect from socket.
2. Charging up the Lithium rechargable battery
Connect the output plug of the supplied 5V AC adapter to the USB port 22
of the unit, make sure the polarity is correct. With the parent unit being
switched off, the power on icon 1 8 will start flashing red, indicating the
battery is being charged. Once the battery is fully charged up (normally it
takes around 3 hours), the indicator 18 turns steady green. Now the parent
unit can be switched on for operation. Either you can disconnect the AC
adaptor or keep connecting will cause no damage to the battery. In the
latter case, when the battery is being consumed and voltage falls to a
certain level, the AC adapter will automatically start charging up the battery
again.
Note : Before using the parent unit for the first time, charge up the Li
battery pack for at least three hours. Besure to switch off the unit before
charging.
Even without the Li battery pack being installed, the unit can still
operate normally once connecting to the AC adapter, while the power on
icon will always stay steady green.
CAUTION : BESURE THE BATTERY IN THE PARENT UNIT IS
RECHARGEABLE TYPE BEFORE CONNECTING TO AC ADAPTER,
OTHERWISE EXPLOSION MAY RESULT.
18
22
5