Bambi BC-62 Instruction Manual page 7

PAIRING
This process is to match the parent unit with baby unit so that they can
communicate with each other while no other devices (even baby monitor of identical
model) can interfere with you or receiving your signal.
The baby and parent unit are already paired with factory preset code when they are
shipped from factory. However, we recommend to perform pairing again in case
interference is experienced:
1. First press and hold the
2. Press the power ON-OFF button
starts flashing green. Release both buttons 13 & 15 .
3. Now press and hold the
4. Press the power ON-OFF button
7 starts flashing green. Release both buttons
5. Now short press the power ON-OFF button
6. If pairing is successful, the power on icons
unit should stop flashing, at the same time, 2 beep sound will be heard from the
parent unit.
7. Long press buttons 1 & 13 to switch off both baby and parent units and then
switch them on again, the baby monitor is now ready for operation.
8. In case the baby and parent unit cannot communicate with each other, repeat
steps 1 - 7 again.
button 15 of parent unit.
13 and wait until the power on icon
button 11 of baby unit.
1 and wait until the power on icon
7
1 & 11 .
1 of baby unit.
18 & 7 on both baby & parent
18