Notes On Use - Sony FA-WRC1M Manual

To shoot by pressing the camera's shutter button
You can perform remote release shooting by pressing the shutter button on the camera to
which the product is attached.
Attach the product to the Multi Interface Shoe of the camera, and then press the camera's
shutter button.
Set the camera's [Flash Mode] to [Wireless].
You do not need to connect the Multi/Micro USB Terminals of the product and the camera
using a Multi Terminal Connecting Cable.
Note
To use a flash (sold separately) during remote release shooting, attach the flash to the
camera's Multi Interface Shoe. The flash cannot be used if it is attached to the Multi
Interface Shoe on the Wireless Radio Receiver.

[12] Notes on use

Notes on use
Product
Do not put the camera inside a bag, etc. with the product attached. This may cause the
camera and the product to malfunction.
When this product and the camera are attached, do not carry them by holding the product.
This may cause a malfunction.
When closing the battery cover, push it in firmly while sliding it all the way across. Be
careful not to catch your finger in the battery cover when closing it. This may cause your
finger to be injured.
Batteries
When using alkaline batteries, the battery level displayed on the LCD panel may be lower
than the actual battery level and the low-battery indicator may appear on the screen
depending on the temperature and storage conditions. The displayed battery level may
revert to the correct value after the product has been used for a while.
When using nickel-metal hydride batteries, the performance of the batteries may be
decrease suddenly once the remaining level has become low. During shooting, just the
low-battery indicator may blink on the screen after which the product can no longer be
used, or the product may turn off suddenly after the low-battery indicator starts blinking.
Remove and store the batteries when you do not intend to use the product for a long
period of time.