¶ ¶ Control
[1] Dip Switch Functions and Their Factory Settings
1. Unit
(1) Main board
Error history deleted
Resets the pre-error data overwrite protection. *4
Sets the restart interval for the
delay mode. *4, *5
*4 This function is available on ver. 1.24 or later.
*5 When setting DipSW3-10 to ON, make sure that the water flow rate in the system is greater than the minimum design amount.
*6
This switch is reset when set from OFF to ON.
Normal
Deleted
Keep overwrite protection
Reset overwrite protection
9 seconds
9 minutes and 59 seconds
- 38 -
*6
Before power on