System Adjustment; Selecting Genlock Signal And Adjusting Phase - FOR-A VTW-350HS Operation Manual

4. System Adjustment

The dedicated utility software, FOR-A MBP Utility allows you to select a genlock signal, adjust the
genlock phase, select a mix mode and set to mix the text on the video.
To use the FOR-A MBP Utility, connect a monitor, a mouse and a keyboard.
The FOR-A MBP Utility and the VTW software cannot be run on the VTW-350HS at
the same time.

4-1. Selecting Genlock Signal and Adjusting Phase

1. Exit the VTW software.
2. Double-click the FOR-A_MBP_Utility icon on the desk top to start the application.
3. The FOR-A_MBP_Utility starts up, and the Info page opens. In the Info page, the
information about the installed boards can be seen.
4. Select Genlock tab.
5. Select a Video format to set the genlock.
6. Select a Genlock format.
BB Black burst
TRI Tri-level sync
7. Genlock status is indicated.
Indication
LOCK The signal is properly locked. The
specified reference input is
present in GENLOCK IN.
UNLOCK The present reference input is not
the one specified. For example, a
Tri-level sync signal is present
when a Black burst is selected.
NONE No reference input in GENLOCK
IN.
IMPORTANT
Status
Not needed
Check the reference input, and input
proper reference signal.
The box indication changes to LOCK,
if a proper reference signal is input.
Check the reference input, and input a
proper reference signal.
The box indication changes to LOCK,
if a proper reference signal is input.
15
10
4
5
6
7
8
9
Remedy