Symbol WS5100 Reviewer's Manual page 21

Symbol WS 5100 Wireless Switch Reviewer's Guide
To add the WS5100 to the wired and wireless networks, and prepare it for
initial configuration, and follow the steps below. Refer to the diagram on the
previous page as needed.
1. Using a Category 6 Ethernet cable, connect a PoE (Power over Ethernet) LAN
switch (Switch A) to the Eth1 Ethernet port (the left side port) on the front panel
of the WS5100.
2. Connect the Access port(s) to Switch A.
3. Using a Category 6 Ethernet cable, connect another LAN switch (Switch B) to
the Eth2 Ethernet port (the right side port) on the front panel of the WS5100.
4. Using the supplied console cable, connect the serial port on the WS5000) to an
RS-232 (DB-9) serial port on a separate computer (the "configuration computer").
5. On the configuration computer, configure a terminal emulation application (such
as HyperTerminal) as follows:
Terminal Type
Port
Terminal Settings
Note that the WS5100 does not need to be fully deployed into the wired or
wireless networks to complete the installation steps outlined in "Preliminary
Configuration through the CLI".
VT-100
COM 1-4 (depending on which COM port
you're using.)
19200 bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression
13