In The Event Of A Problem - Rowenta HU523 SERIES Instructions Manual

1800140511-01_ RO_HUMIDIFICATEUR AQUA PERFECT_HU52_US-CA_IFU.qxp_1800140511-01 18/04/2017 16:38
EN
You can also use the ANTICALC KIT of KRUPS, sold as accessory, F054 (F0540051).
Please notice, only 20 grams of the powder are necessary for the descaling operation of your device.
IMPORTANT: Never use abrasive cleaners as these are likely to spoil the appearance of your appliance.
Instead, clean your appliance with a slightly moist rag and the brush provided with the device.
If you have any questions, please see the ROWENTA international guarantee card enclosed with this
product, where you will find the Consumer Service contact details.
STORAGE
When the appliance is not in use, it should be stored in a dry place.
Make sure to empty the tank, clean and dry the appliance before storing it.

IN THE EVENT OF A PROBLEM

Never dismantle your appliance yourself. An incorrectly repaired appliance can be a danger to the user.
Before contacting an approved Service Centre from our network, make sure that the appliance is in the
normal operating position and the air intake and outlet grills are totally unobstructed.
P roblem
The appliance does
not work when swit-
ched on
The humidification ca-
pacity is too low
The ambient humidity
is too high
There is condensation
in the room
Possible Cause
The target humidity is reached.
The water level indicator is
blinking.
The water tank isn't well posi-
tioned.
The appliance isn't on a flat
surface.
The water level required has
not yet reached the vaporiza-
tion compartment.
The HR% of the room is over
90%.
There is natural or artificial air
replacement in the room which
interfere the increase of HR%.
The air inlet grids and nozzle
could be blocked.
There is too much scale in the
water basin or on the piezo
part.
The Humidity selected rate is
too low.
The appliance is working in
CONTINUOUS MODE.
The humidity target is too high. Select a lower HR% target.
The room temperature is too
low.
Increase the target humidity in CONTROL
MODE or select CONTINUOUS MODE.
Refill the water tank.
Check the positioning of the tank on the
base.
Check the positioning of the appliance (tilt).
Wait at least 20 secs.
Wait till the HR% of the room gets below
80%.
Check if doors and windows are closed.
Check if there is no air conditioning working
in the room.
Remove any blocking items from the grids
and the nozzle.
Clean the water base according to Mainte-
nance Instructions.
Increase Vaporization Speed in CONTROL
MODE.
Increase Humidity setting in CONTROL
MODE.
Change the mode.
Heat the room up.
1
What to do