Dismantling Instructions; Open Dvd Tray / Removal Of Cover Dvd Tray Manually; Removal Of The Jog Shuttle & Volume Knobs; Open The Cdc Tray / Removal Of Cover Cdc Tray & Cdc Module Manually - Philips FW-D5/21 Service Manual

DISMANTLING INSTRUCTIONS

1. Open DVD Tray / Removal of Cover DVD Tray manually

Note: Steps a) and b) are meant strictly for sets with
a jammed tray that cannot be open via the
Open/Close button.
a) With a Torx screw driver, make a marking of about 5.5cm
from the tip as shown below.
Marking 5.5cm
from the bit end
Torx Screw bit diameter 3.5mm
Figure 1
b) Insert the tip of the screw driver into the slot S1 provide
at the bottom of the Cabinet Front.
Direction of
screw bit
S1
C
C
Figure 2
Keep the marking just outside the slot & rotate the screw
driver upwards lightly as shown below.
Cover DVD Tray
Rotate upwards
Figure 3
The DVD Tray should jerked outwards slightly.
This process is a simulation of pushing the white lever on
the DVD Module inwards (see Figure 4).
3-1
Push white lever
inwards as indicated
to open the DVD Tray
Figure 4
Note: This procedure is best done with the set laying on
its side as shown, but when there is any jammed
or foreign material in the tray it has to be done with
the set placed upright at the edge of the table or
work bench.
c) Pull the tray out and the Cover DVD Tray (pos 160) or any
jammed disc can be removed. The Cover DVD Tray is
removed as shown below.
Figure 5
2. Removal of the Jog Shuttle & Volume knobs
a) Insert a strong string into the slot between the Jog Sound
knob (pos 135) and Ring Ornamental (pos 144). Looped
it 1,5 turns securely around the Jog Sound knob and
pulled it out as shown in fig. 6
b) Do likewise for the Jog DVD knob (pos 135) and Volume
knob (pos 139).
3. Open the CDC Tray / Removal of Cover CDC Tray & CDC module manually
a) Loosen 16 screws to remove the Cabinet Cover (pos
259).
- 5 screws on each side
- 6 screws on the rear
b) Slide out the CDC Tray as shown by using a finger or a
flat screw driver to turn the gear towards the front and
remove the Cover Tray CDC assembly (pos 106 & 107)
as shown below.
Figure 7
3-1
Figure 6
c) Loosen 2 screws A on the front as shown below.
A
Figure 8
d) Loosen 2 screws B at the Rear and remove the CDC
Module (pos 1104) as shown below.
B
Figure 9
PCS 103 816